Open Access
EPJ Web of Conferences
Volume 114, 2016
EFM15 – Experimental Fluid Mechanics 2015
Article Number 02021
Number of page(s) 5
Section Contributions
Published online 28 March 2016
  1. R. Cascone, Chem. Eng. Prog. 104, p. S4–S9, (2008)
  2. P. Patakova, D. Maxa, M. Rychtera, L. Linhova et al., M.A.D.S., ISBN 978-953-307-480-1, p. 243–266, InTech, Rijeka, Croatia, (2011)
  3. B. Jones, G. Mead, P. Steevens, “The Effects of E20 on Plastic Automotive Fuel System Components” Tech. Rep. 20082/21/2008, Minnesota Center for Automotive Research, (2008).
  4. B. Bailey, “Performance of Ethanol as a Transportation Fuel,” In: Handbook on Bioethanol: Production and Utilization. Edited by Wyman C. E. Online at (accessed October 10, 2015).
  5. EPA (Environment Protection Agency U.S.), “1-Butanol as a Gasoline Blending Bio-component,” BP, Mobile Sources, Technical Review Subcommittee, March 28, (2007),
  6. S. Szwaja, J. D. Naber, Fuel, 89, Issue 7, p. 1573–1582, (2010), doi:10.1016/j.fuel.2009.08.043. [CrossRef]
  7. F. N. Alasfour, Int. J. of Energy Research, 21, Issue 1, p. 21–30, (1997), doi:10.1002/(SICI)1099-114X(199701)21:1<21::AID-ER231>3.0.CO;2-K. [CrossRef]
  8. T. Wallner, A. Ickes, N. Shidore, “Impact of ethanol and butanol as oxygenates on SIDI engine efficiency and emissions using steady-state and transient test procedures,” DEER 2010, Detroit, Michigan, September 27-30, (2010).
  9. A. Cairns, A. Todd, P. Aleiferis, N. Fraser, et al., “A Study of Alcohol Blended Fuels in an Unthrottled Single Cylinder Spark Ignition Engine,” SAE Technical Paper 2010-01-0618, 17, (2010), doi:10.4271/2010-01-0618
  10. M. Thewes, M. Müther, A. Brassat, S. Pischinger et al., “Analysis of the Effect of Bio-Fuels on the Combustion in a Downsized DI SI Engine,” SAE Int. J. Fuels Lubr. 5(1), p.274–288, (2011), doi:10.4271/2011-01-1991. [CrossRef]
  11. S. Merola, C. Tornatore, G. Valentino, L. Marchitto, et al., “Optical Investigation of the Effect on the Combustion Process of Butanol-Gasoline Blend in a PFI SI Boosted Engine,” SAE Technical Paper 2011-24-0057, 15, (2011), doi:10.4271/2011-24-0057.
  12. Chemistry Webbook. National Institute of Standards and Technology. Online at
  13. V. F. Andersen, J. E. Andersen, T. J. Wallington, S. A. Mueller, et al., “Vapor Pressures of Alcohol-Gasoline Blends,” Energy & Fuels, 24, p. 3647–3654, (2010), doi:10.1021/ef100254w [CrossRef]
  14. S. P. Sutera, R. Skalak, “The history of Poiseuille’s law”. Annual Review of Fluid Mechanics 25: pp. 1–19 (1993). [CrossRef]
  15. C. O. Bennett, J. E. Myers, Momentum, Heat, and Mass Transfer, McGraw-Hill (1962).
  16. P. G. Aleiferis, J. Serras-Pereira, Z. van Romunde, J. Caine, M. Wirth, Combustion and Flame 157, pp. 735–756, (2010). [CrossRef]
  17. J. P. Holman, Heat Transfer, p. 207, (2002).
  18. M. C. Potter, D. C. Wiggert, B. H. Ramadan, T. I. P. Shih, Mechanics of fluids (Fourth edition. ed.). Cengage Learning (2012).
  19. D. Kolokotronis, Y. Hardalupas, A. Taylor, P. Aleiferis et al.: “Experimental Investigation of Cavitation in Gasoline Injectors”, SAE Technical Paper 2010-01-1500, 23, (2010), doi:10.4271/2010-01-1500.
  20. T. N. C. Anand, A. Madan Mohan, R. V. Ravikrishna, “Spray characterization of gasolineethanol blends from a multi-hole port.”, Fuel, 102, 10, (2012)
  21. J. Gao, D. Jiang, Z. Huang, “Spray properties of alternative fuels: A comparative analysis of ethanol–gasoline blends and gasoline.”, Fuel, 86, 5, (2007)