Exclusive diffractive results from ATLAS, CMS, LHCb, TOTEM at the LHC

. In this report, we describe the most recent on exclusive di ﬀ raction from the ATLAS, CMS, LHCb, TOTEM experiments at the LHC


Introduction: Definition of exclusive diffraction
We will start this report by defining what we call "Exclusive" diffraction.The first left diagram of Fig. 1 corresponds to Double Pomeron Exchanges in inclusive diffraction.In this event, both protons are intact in the final state and two pomerons are exchanged.Gluons are extracted from each pomeron in order to produce jets.Some energy is lost in pomeron remnants.The three other diagrams in Fig. 1 are exclusive in the sense that the full energy is used to produce the diffractive object.In other word, there is no energy loss in pomeron remnants.The second diagram corresponds to exclusive diffraction [1], the third one to photon exchanges and the last one to photon pomeron exchanges that produce vector mesons.In the following, we will discuss the measurements at the LHC corresponding to these different diagrams.

Low mass exclusive diffraction
In this section, we will focus on low mass exclusive diffraction results from LHCb and CMS, namely on vector meson and pion production.
EPJ Web of Conferences 172, 06007 (2018) https://doi.org/10.1051/epjconf/201817206007ISMD 2017  In Fig. 2, we display three diagrams that correspond to exclusive productions in LHCb.The first left diagram corresponds to the QED production of di-muon, the middle one the photoproduction of J/Ψ, and the right one the inclusive Double Pomeron Exchange production of χ C mesons.The exclusive production of J/Ψ is strongly sensitive to the gluon distribution in the proton since it appears as a square dependence in the amplitude.The signal is to measure the J/Ψ in the central part of LHCb and the background is due to inclusive diffractive processes where the pomeron remnants are not detected since exclusive processes are selected via the rapidity gap method.The issue is the gap detection since, for some events, the pomeron remnants are outside detector acceptance.

Measurement of central exclusive production in LHCb
In order to improve the coverage at high rapidities, the LHC collaboration installed a new detector called HERSCHEL (High Rapidity Shower Counter for LHCb).HERSCHEL is installed on both sides of LHCb and allows a coverage in pseudo rapidity of −10.0 < η < −3.5 and 5.0 < η < 10.0 which leads to a coverage of LHCb of −10.0 < η < −1.5 and 2.0 < η < 10.0.Herschel was used to select exclusive data at 13 TeV, and the differential cross sections for J/Ψ and Ψ(2S ) compared between 7 and 13 TeV data are shown in Fig. 3 [2].The results are in agreement with NLO calculations and the best PDF parametrisation is from JMRT [3].
This measurement allow LHCb to compare with previous measurements performed by the H1 and ZEUS collaborations at HERA using the following simple relation between HERA and LHCb measurements where the pp → pV p is measured by LHCb, σ(W − ) (resp.σ(W + )) at HERA, and W + i(resp.W − ) s extracted from the previous formula.The results are shown in Fig. 4 [2] and a simple power law does not lead to a good description of data.In this section, we will describe the measurement of exclusive pion production by the CMS collaboration [4].The two diagrams that are dominant at low masses are shown in Fig. 5.The left diagram corresponds to double pomeron exchange and is implemented in the DIME Monte carlo [5] whereas the right diagram corresponds to γ-pomeron exchanges producing a ρ meson that decays into a pion pair as implemented in the STARLIGHT Monte Carlo [6].The measurement was performed using low pile up runs since the production cross section is high and not much accumulated luminosity is needed.The same measurement in a high pile up environment would be challenging because of the low p T track requirement.The experimental signature is to request two opposite tracks from the same primary vertex and no additional signal in the calorimeter outside the two pions with p T (π) > 0.2 GeV and |y(π)| < 2. The background is computed using same sign events directly in data.

Measurement of exclusive pion production in CMS
The measurement of the di-pion cross section is shown in Fig. 6 in both linear and logarithmic scales [4].We see a discrepancy between the measurements and the sum of the DIME and STARLIGHT Monte Carlo expectations both in shape and normalization.Both Monte Carlos do not contain proton dissociation and it might be a reason for most of the discrepancy (since the measurements require the existence of a rapidity gap in the CMS detector, it is impossible to distinguish experimentally between the cases when the protons are intact or dissociate).The exclusive pion cross section was measured to be σ π + π − = 26.5 ± 0.3 (stat) ±5.0 (syst) ±1.1 (lumi) µb.

Exclusive measurements at high mass and photon exchange processes
In this section, we will describe the results on exclusive production at high mass together with the ones on photon exclusive exchange processes.

ATLAS and CMS results on exclusive WW production
ATLAS and CMS measured the exclusive production of a pair of W bosons pp → pWW p using the rapidity gap technique.This measurement is motivated by the search for quartic anomalous γγWW couplings defined as additional terms in the SM lagrangian All parameters are equal to 0 in the SM.
This search has to be performed using the highest possible integrated luminosity at the LHC since exclusive WW events are rare which means at high pile up at the LHC.The CMS and ATLAS collaborations used respectively 19.7 fb −1 and 20.2 fb −1 at a center-of-mass of 8 TeV (and CMS an additional 5.05 fb −1 at 7 TeV).The exclusivity selection requires opposite sign electron and muon originating from the common primary vertex and no extra track from that vertex.In addition, M eµ > 20 GeV to avoid the low mass resonance region and P eµ T > 30 GeV to remove Drell-Yan and γ → ττ events.
CMS and ATLAS measured the exclusive WW production and obtained σ(pp Since data are in agreement with the standard model, it is possible to obtain the most stringent limits to date on γγWW quartic anomalous coupling and the results are given in Fig. 7.It is worth noticing that these limits can potentially be improved by about two orders of magnitude measuring the intact protons in the final state using the CT-PPS and AFP detectors [8].

Exclusive di-muon production and the AFP and CT-PPS detectors
The Atlas Forward Proton [9] (AFP) and CMS-TOTEM Precision Proton Spectrometer [10] (CT-PPS) detectors were installed recently in order to detect and measure intact protons in the final state that leads to a possible better identification of exclusive events.The LHC magnets bend the scattered protons outside the beam envelope.The roman pots detectors are located at about 210-220 m from the center part of the CMS or ATLAS detectors and cover a region in diffractive mass between typically 350 and 2000 GeV depending on the beam lattice.The CT-PPS detector started taking data in 2016 and could accumulate about 15 fb −1 in 2016.Both CT-PPS and AFP have been taking data continuously in 2017.
The ATLAS and CMS collaborations measured in 2016 the exclusive di-muon production with two different strategies.The corresponding diagrams are shown in Fig. 8.The LHC is turned into a γγ collider and the flux of quasi-real photons is computed using the Equivalent Photon Approximation.ATLAS did not have the possibility of detecting intact protons at the time of this measurement, and they selected exclusive µµ production using the rapidity gap technique.The exclusivity requirement in presence of pile up is that zero additional track exists within 1 mm of the µ + µ − vertex.From the rapidity gap technique, it is impossible to know if the protons are dissociate or not and the measurement corresponds to the three diagrams shown in Fig. 8.The ATLAS collaboration fitted the µµ acoplanarity distribution at 13 TeV using 3.2 fb −1 of data in order to extract the fiducial cross section for p µ T > 6 GeV (12 < m µµ <30 GeV) and for p µ T > 10 GeV (30 < m µµ <70 GeV) and found σ excl.f id γγ→µµ = 3.12±0.07(stat)±0.10(syst)pb [11].The comparison with the Superchic Monte Carlo [12] indicates an insufficient suppression in Monte Carlo due to absorptive effects.
The CT-PPS collaboration measured exclusive di-muon production by tagging one intact proton in the final state.This is the first time the semi-exclusive di-muon processes are measured with proton tag.In Fig. 8, the two left diagrams correspond to the signal whereas the rightmost diagram is part of the background.The reason that only one proton is requested to be tagged is that less than one event is expected for double tagged events with about 15 fb −1 of data due to the mass acceptance above about 350 GeV for the forward proton detectors.The main background is due du Drell-Yan dimuon production with the intact proton originating from pile up events.This background is estimated using Drell-Yan Z events in data and extrapolating from the Z peak region to our exclusive di-muon signal region.17 events are found with protons in the CT-PPS acceptance and 12 show a less than 2σ matching between the values of ξ computed using the TOTEM roman pots and using the di-muon measured in CMS as shown in Fig. 9 [13].
The correlation between the di-muon mass and rapidity is shown in Fig. 10.We see that there is no event with two protons tagged due to the acceptance in mass of the TOTEM roman pots.The highest di-muon mass events is at 341 GeV.This analysis shows that CT-PPS is now working perfectly and that we have a good understanding of triggers, data taking, forward detector alignment...

Exclusive di-photon production via photon exchanges
The ATLAS collaboration recently measured exclusive di-photon production in PbPb production at the LHC.Exclusive di-muons can be produced via photon exchanges and the cross section is enhanced by a factor Z 4 with respect to the pp case.In 480 µb −1 of PbPb data at √ s =5.02 TeV, 13 events were observed for an estimated background of 2.6±0.7.For photon E T > 3 GeV, |η| < 2.4, M γγ >6 GeV, p γγ T < 2 GeV:, ATLAS measured σ = 70 ± 24(stat) ± 17(syst) nb in agreement with Standard Model expectations [14].
Using CT-PPS and AFP, it is also possible to search for γγγγ anomalous couplings in a very clean way.Within the acceptance of the CT-PPS and AFP detectors during standard high luminosity runs at the LHC (basically for a di-photon mass above 350 GeV), it is possible to show that the exclusive production of di-photons is completely dominated by photon exchange processes and gluon exchanges can be neglected.Since the signal only shows two photons and two intact protons in the final state, we measure all final state particles.That allows us to obtain a negligible background for 300 fb −1 at the LHC.The basic idea is to compare the proton missing mass and the di-photon mass as  shown in Fig. 11, left [15].The signal peaks around 1.0 and the gaussian width is due to the detector resolution whereas the pile-up background leads to a much flatter distribution since the two protons are not related with the two photons.The same requirement can be performed using the difference in rapidity between the di-photon and di-proton systems.This leads to a sensitivity better by two orders of magnitude to γγγγ anomalous couplings compared to other methods at the LHC without detecting intact protons [15].It is possible to show that the gain of two orders of magnitude is also valid for γγWW and γγZZ anomalous couplings whereas the gain reaches three orders of magnitude for γγγZ anomalous couplings [8,17].The search for anomalous couplings with tagged protons is now being pursued by both CMS-TOTEM and ATLAS collaborations.

Conclusion
We discussed many complementary measurements concerning exclusive production at the LHC from the ATLAS, CMS, LHCb and TOTEM experiments either using the "rapidity gap" technique or the proton tags.The LHCb collaboration measured the J/Ψ and Ψ(2S ) production and the preferred model is JMRT at NLO.The CMS exclusive pion measurement is in disagreement with theoretical expectations which is probably due to the fact that proton dissociation is not included in models.The exclusive production of W pair production was observed and led to the best limits to date on γγWW anomalous couplings.For the first time, the CMS and TOTEM collaborations observed the exclusive production of di-muons at high mass with a proton tag.Last but not least, AFP and CT-PPS open a completely new search for quartic anomalous couplings between γ, W and Z bosons with a gain in reach by two or three orders of magnitude compared to more standard methods at the LHC, reaching some of the values predicted by extra-dimension or composite Higgs models.

Figure 1 .
Figure 1.Diagrams of inclusive and exclusive diffractive processes.

Figure 3 .
Figure 3. Measurement of the J/Ψ and Ψ(2S ) cross sections as a function of rapidity using 7 and 13 TeV data.The 13 TeV data include the new HERSCHEL detector..

Figure 4 .
Figure 4. Measurement of the γp → J/Ψp and γp → Ψ(2S )p cross sections as a function of renergy using 7 and 13 TeV data.Data cannot be described by a simple power law.

Figure 5 .
Figure 5.Leading diagrams leading to exclusive pion production.

Figure 6 .
Figure 6.Measurement of exclusive pion cross section by the CMS collaboration as a function of the di-pion mass in linear and logarithmic scales.

Figure 7 .
Figure 7. Limits on γγWW quartic anomalous couplings by the CMS and ATLAS collaborations..

Figure 9 .
Figure 9. Correlation between the ξ values computed using the TOTEM roman pots and the di-muon measured in CMS.The 12 semi-exclusive events are indicated in red.The left (right) plot displays the left (right) arm of TOTEM.

Figure 10 .
Figure 10.Correlation between the di-muon mass and rapidity showing the semi-exclusive di-muon events on the left and right arms of TOTEM.

Figure 11 .
Figure 11.Left: Ratio between the proton missing mass and di-photon mass for exclusive di-photon signal events and background.Right: Difference between the di-photon and di-proton rapidity for exclusive di-photon signal and background.