EPJ Web of Conferences
Volume 25, 2012EFM11 – Experimental Fluid Mechanics 2011
|Number of page(s)||10|
|Section||Experimental Fluid Mechanics 2011|
|Published online||16 April 2012|
Low cost membrane contactors based on hollow fibres
1 Knowledge Engineering Centre, Faculty of Business and Management, Brno University of Technology ; CZ
Mirko Dohnal, firstname.lastname@example.org
2 Heat Transfer and Fluid Flow Laboratory, Faculty of Mechanical Engineering, Brno University of Technology, Technicka 2896/2 ; 616 69, Brno ; CZ
Tomas Vesely, email@example.com, Miroslav Raudensky, firstname.lastname@example.org
Membrane contactors are used to solve different chemical engineering tasks (e.g. water saturation with gases). Such elements are traditionally used for bubble less oxidation of blood. However, their industrial applications are rather limited by their high investment costs. This is probably the main reason why membrane contactors are not used so widely, e.g. classical absorbers, etc. If potted bundles of hollow fibres are available, then it is a relatively simple task to design an ad hoc membrane contactor. However, it must be emphasised that to achieve the highest mass transfer efficiency requires a rather time-consuming tuning of each ad hoc designed contactor. To check the differences by water evaporation were aligned two modes, the water inside the hollow fibre membrane and fan air outside, next with the water outsides and flowing pressure air inside the membrane.
© Owned by the authors, published by EDP Sciences, 2012
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.