Measurements of the velocity fields by PIV method round about titling gate

Institute of Water Structures, Faculty of Civil Engineering, Brno University of Technology, 602 00 Brno, Veveří 331/95, 541 147 191
mistrova.i@fce.vutbr.cz ; mistrova.ivana@centrum.cz ; zubik.p@fce.vutbr.cz

Abstract

The article deals with problems of using of measurement method Particle Image Velocimetry (PIV) to measure velocity fields in the flowing water in front, above and behind drowned titling weir gate. The aim was to obtain information about the distribution of speed in the area of interest for the verification or calibration of the numerical model. Experiments were carried out in inclinable channel connected to the hydraulic circuit with a pump and storage tank at the Water Management Research Laboratory (LVV) of Institute of Water Structures at the Faculty of Civil Engineering in Brno University of Technology. Hydraulic inclinable channel has cross-section with dimensions of 0.4×0.4m and length of 12.5m. The measured area has cross-section approximately 0.2m wide and 0.4m high and its length is 1m. The results of physical modelling allowed a comparison of experimental data with numerical simulation results of this type of flow in the commercial software ANSYS CFX-12.0.