EPJ Web of Conferences
Volume 94, 2015DYMAT 2015 - 11th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading
|Number of page(s)||4|
|Published online||07 September 2015|
The effect of cutting speed on residual stresses when orthogonal cutting TC4
1 Key Laboratory of Ministry of Education for Contemporary Design and Integrated Manufacturing Technology, Northwestern Polytechnical University, Xi'an 710072, China
2 Northwestern Polytechnical University, School of Aeronautics, Xi'an 710072, China
a Corresponding author: firstname.lastname@example.org
Published online: 7 September 2015
As one of the most important parameters in mental cutting, cutting speed has a significant influence on residual stress. Finite element method and experiment method are used to study the relationship between cutting speed and residual stress when orthogonal cutting TC4 titanium alloy. The result of simulation and experiment shows that: when the cutting speed is low, the residual stress in axial direction is compressive stress and gradually converts to tensile stress with the increase of cutting speed, but it will convert to compressive stress again if the cutting speed continues to increase; the residual stress in tangential direction is constant to compressive stress and it will decrease with the increase of cutting speed.
© Owned by the authors, published by EDP Sciences, 2015
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.