EPJ Web Conf.
Volume 143, 2017EFM16 – Experimental Fluid Mechanics 2016
|Number of page(s)||4|
|Published online||12 May 2017|
Experimental validation of mathematical model for small air compressor
Brno University of Technology, Faculty of Mechanical Engineering, Energy Institute, Technicka 2896/2, Brno 616 69, Czech Rep.
* Corresponding author: email@example.com
Published online: 12 May 2017
Development process of reciprocating compressors can be simplified by using simulation tools. Modelling of a compressor requires a trade-off between computational effort and accuracy of desired results. This paper presents experimental validation of the simulation tool, which can be used to predict compressor behaviour under different working conditions. The mathematical model provides fast results with very good accuracy, however the model must be calibrated for a certain type of compressor. Small air compressor was used to validate an in-house simulation tool, which is based on mass and energy conservation in a control volume. The simulation tool calculates pressure and temperature history inside the cylinder, valve characteristics, mass flow and heat losses during the cycle of the compressor. A test bench for the compressor consisted of pressure sensors on both discharge and suction side, temperature sensor on discharge side and flow meter with calorimetric principle sensor.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Initial download of the metrics may take a while.