Issue |
EPJ Web Conf.
Volume 180, 2018
EFM17 – Experimental Fluid Mechanics 2017
|
|
---|---|---|
Article Number | 02075 | |
Number of page(s) | 7 | |
Section | Contributions | |
DOI | https://doi.org/10.1051/epjconf/201818002075 | |
Published online | 04 June 2018 |
https://doi.org/10.1051/epjconf/201818002075
CFD simulation of ejector: is it worth to use real gas models?
Department of Power Engineering Equipment, Faculty of Mechanical engineering, Technical University of Liberec, Czech Republic
a Corresponding author: nguyen.van.vu@tul.cz
Published online: 4 June 2018
This paper presents progress of evaluation existing ejector of previous work with different gases, included real gas. This work was done by the Ansys simulation tool. The paper also discussed about the two solvers used for simulating real gas difluoromethane (R32). The results showed that entrainment ratios are almost not influenced by different gases but by the working conditions. Secondly, the solver pressure-based can obtain comparable results with the density-based one, while it is much more stable and solution converges faster than the density-based.
Key words: difluoromethane / real gas / ejector / entrainment ratio / pressure-based / density-based
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (http://creativecommons.org/licenses/by/4.0/).
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.