EPJ Web Conf.
Volume 229, 202029th International Conference of the International Nuclear Target Development Society (INTDS2018)
|Number of page(s)||7|
|Section||Targets for High Intensity Beams|
|Published online||28 February 2020|
Multi-jet gas cooling of in-beam foils or specimens: CFD predictions of the convective heat-transfer coefficient
1 iThemba LABS, National Research Foundation, P.O. Box 722, Somerset West, 7129, South Africa
2 Isotope Program, Los Alamos National Laboratory, Los Alamos, NM 87545, USA
3 Stellenbosch University, Matieland, 7602, South Africa
Published online: 28 February 2020
An experiment was designed to investigate the possible enhancement of the convective heat-transfer coefficient by utilizing multiple, parallel jets in the cooling of a small heated surface, such as typically induced by an accelerated ion beam on a thin foil or specimen. The hot spot was provided using a small electrically heated plate. It was found that heat-transfer calculations by means of simple empirical methods based on dimensional analysis are not useful in this case and that advanced computational fluid dynamics (CFD) mod-elling is essential to interpret the results. It is shown that enhanced convective cooling can indeed be obtained with a multi-jet configuration as compared to a single-jet configuration but only under very selective conditions. An improperly designed multi-jet configuration can also provide significantly reduced cooling relative to the single-jet case and the estimation of the behavior of any particular jet geometry is eminently non-intuitive. CFD provides acceptable quantitative results and seem to be the only tool available to gain an understanding of these complex flows where simple models and “rules of thumb” cannot be relied upon. – LA-UR-18-29455
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.