EPJ Web Conf.
Volume 242, 2020International Workshop on Fission Product Yields (FPY 2019)
|Number of page(s)||6|
|Published online||28 September 2020|
New Fission Product Yield Measurements at Oregon State University
1 Oregon State University
2 Lawrence Livermore National Laboratory
* e-mail: firstname.lastname@example.org
Published online: 28 September 2020
Cumulative fast fission product yields for 235 U and 238 U were measured at Godiva-IV in burst mode. Data was collected starting 45 minutes after the prompt irradiation. Data analysis codes were developed to analyze gammarays and calculate fission product yields with their respective uncertainties. Due to uncertainties in the branching ratios, different γ-rays from the same isotope led to different fission yield. This led to an effort at Oregon State University (OSU) to utilize the Rabbit facility at their 1 MegaWatt Training, Research, Isotopes, General Atomics (TRIGA) nuclear research reactor. The new experimental setup will allow us to measure branching ratio data and short-lived fission product yields starting seconds after a prompt irradiation.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.