Open Access
Issue
EPJ Web Conf.
Volume 140, 2017
Powders and Grains 2017 – 8th International Conference on Micromechanics on Granular Media
Article Number 02019
Number of page(s) 4
Section Granular solids
DOI https://doi.org/10.1051/epjconf/201714002019
Published online 30 June 2017
  1. R. H. Kuerbis, D. Negussey, and Y. P. Vaid, “Effect of gradation and fines content on the undrained response of sand,” Geotech. Spec. Publ., no. 21, pp. 330–345, (1988).
  2. C. P. Polito and MartinJ. R. II, “A reconciliation of the effects of non-plastic fines on the liquefaction resistance of sands reported in the literature,” Earthq. Spectra, vol. 19, no. 3, p. 635, (2003). [CrossRef]
  3. S. Thevanayagam, T. Shenthan, S. Mohan, and J. Liang, “Undrained fragility of clean sands, silty sands, and sandy silts,” J. Geotech. Geoenvironmental Eng., vol. 128, no. 10, pp. 849–859, (2002). [CrossRef]
  4. Q. Ni, T. S. Tan, G. R. Dasari, and D. W. Hight, “Contribution of fines to the compressive strength of mixed soils,” Géotechnique, vol. 54, no. 9, pp. 561–569, (2004). [CrossRef]
  5. S. A. Naeini and M. H. Baziar, “Effect of fines content on steady-state strength of mixed and layered samples of a sand,” Soil Dyn. Earthq. Eng., vol. 24, no. 3, pp. 181–187, (2004). [CrossRef]
  6. S. L. Yang, R. Sandven, and L. Grande, “Instability of sand-silt mixtures,” Soil Dyn. Earthq. Eng., vol. 26, no. 2–4 SPEC. ISS., pp. 183–190, (2006). [CrossRef]
  7. S. L. Yang, R. Sandven, and L. Grande, “Steady-state lines of sand-silt mixtures,” Can. Geotech. J., vol. 43, no. 11, pp. 1213–1219, (2006). [CrossRef]
  8. T. G. Murthy, D. Loukidis, J. A. H. Carraro, M. Prezzi, and R. Salgado, “Undrained monotonic response of clean and silty sands,” Géotechnique, vol. 57, no. 3, pp. 273–288, (2007). [CrossRef]
  9. A. Papadopoulou and T. Tika, “The effect of fines on critical state and liquefaction resistance characteristics of non-plastic silty sands,” Soils Found., vol. 48, no. 5, pp. 713–725, (2008). [CrossRef]
  10. M. M. Rahman, S.-C. R. Lo, and C. T. Gnanendran, “On equivalent granular void ratio and steady state behaviour of loose sand with fines,” Can. Geotech. J., vol. 45, no. 10, pp. 1439–1456, (2008). [CrossRef]
  11. C. Stamatopoulos, “An experimental study of the liquefaction strength of silty sands in terms of the state parameter,” Soil Dyn. Earthq. Eng., vol. 30, no. 8, pp. 662–678, Aug. (2010). [CrossRef]
  12. A. Mohammadi and A. Qadimi, “A simple critical state approach to predicting the cyclic and monotonic response of sands with different fines contents using the equivalent intergranular void ratio,” Acta Geotech., May (2014).
  13. N. Benahmed, T. K. Nguyen, P. Y. Hicher, and M. Nicolas, “An experimental investigation into the effects of low plastic fines content on the behaviour of sand/silt mixtures,” Eur. J. Environ. Civ. Eng., vol. 18, Jul. (2014).
  14. W. O. Smith, P. D. Foote, and P. F. Busang, “Packing of homogeneous spheres,” Phys. Rev., vol. 34, no. 9, pp. 1271–1274, (1929).
  15. J. D. Bernal and J. Mason, “Co-ordination of randomly packed spheres,” Nature, vol. 188, pp. 910–911, (1960).
  16. M. Akarawa and M. Nishino, “Contact number and porosity in randomly packed sphere mixtures,” J. Soc. Mater. Sci. Japan, vol. 22, pp. 658–662, (1973). [CrossRef]
  17. M. Oda, “Co-ordination number and its relation to shear strength of granular material,” Soils Found., vol. 17, no. 2, pp. 29–42, (1977). [CrossRef]
  18. J. S. Goodling and M. S. Khader, “Co-ordination number cylindrical bed distribution of spherical particles in a packed,” Powder Technol., vol. 44, no. 1, pp. 53–55, (1985).
  19. R. Y. Yang, R. P. Zou, and A. B. Yu, “Computer simulation of the packing of fine particles,” Phys. Rev. E. Stat. Phys. Plasmas. Fluids. Relat. Interdiscip. Topics, vol. 62, no. 3 Pt B, pp. 3900–3908, Sep. (2000).
  20. C. P. Polito, “The effects of non-plastic and plastic fines on the liquefaction of sandy soils,” Virginia Polytechnic Institute, (1999).

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.