EPJ Web Conf.
Volume 143, 2017EFM16 – Experimental Fluid Mechanics 2016
|Number of page(s)||5|
|Published online||12 May 2017|
Influence of the cutting parameters on the workpiece temperature during face milling
1 Chair of Mechanical Engineering and Metrology, Kielce University of Technology ; Aleja Tysiąclecia Państwa Polskiego 7 ; 25-314 Kielce ; Poland
2 Faculty of Mechatronics and Mechanical Engineering, Department of Automation and Robotics, Kielce University of Technology, Aleja Tysiaclecia Panstwa Polskiego 7, 25-314 Kielce, Poland
3 Department of Mechanics, Kielce University of Technology ; Aleja Tysiąclecia Państwa Polskiego 7 ; 25-314 Kielce, Poland
* Corresponding author: email@example.com
Published online: 12 May 2017
This thesis presents the outcome of experimental research of the impact of changes in cutting speed and volume of material processed during a face milling process on the temperature of the processed object made of copper of M1Ez4 class. Measurement of the temperature of the processed object was conducted in six points with K-type thermocouples. The theoretical amount of released heat per unit of time for particular parameters of machining was also calculated.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.