| Issue |
EPJ Web Conf.
Volume 213, 2019
EFM18 – Experimental Fluid Mechanics 2018
|
|
|---|---|---|
| Article Number | 02097 | |
| Number of page(s) | 7 | |
| Section | Contributions | |
| DOI | https://doi.org/10.1051/epjconf/201921302097 | |
| Published online | 28 June 2019 | |
https://doi.org/10.1051/epjconf/201921302097
Measurement and calculating of supersonic ejectors
Department of Power Engineering Equipment, Faculty of Mechanical Engineering, Technical University of Liberec, Studentska 2, 46117, Liberec, the Czech Republic
* Corresponding author: lukas.vojta@tul.cz
Published online: 28 June 2019
This paper deals with numerical and experimental investigation of the flow in an air to air supersonic ejector with constant area mixing chamber. The mixing chamber of previous ejector was completely repaired since a scratch from previous turning had been found. As a result, a new geometry of the mixing chamber was created. Several measurements were conducted with different nozzle position (NP): 1 mm, 2 mm and 3 mm. Furthermore, for a given NP, two different values of stagnation pressure of 200 kPa and 300 kPa at the primary air inlet were investigated in more detail. All numerical simulations were performed in the ANSYS Fluent software. It was found that the influence of the position of the nozzle influences the ejection factor only to a certain extent. For the other parameters of the ejector is also a need to find the optimum position of the nozzle. Repair of the mixing chamber has contributed to reduce the pressure difference at the wall of the mixing chamber.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.