EPJ Web Conf.
Volume 224, 2019IV International Conference “Modeling of Nonlinear Processes and Systems” (MNPS-2019)
|Number of page(s)||5|
|Section||Mechanical Engineering and Material Sciences|
|Published online||09 December 2019|
Modeling of Residual Stress Distribution for Components Manufactured by Selective Laser Melting
University of Shanghai for science and technology, School of Mechanical Engineering, CN-200093, Shanghai, China
2 Moscow State Technological University “STANKIN”, RU-127055, Moscow, Russia
* e-mail: firstname.lastname@example.org
Published online: 9 December 2019
In this paper, the selective laser melting (SLM) simulation analysis of components is carried out. The residual stress distribution of the formed part was predicted, and the influence of process parameters such as exposure time, laser power and laser scanning speed on the residual stress of the SLM formed part was analyzed. It was found that the residual stress concentration of the formed part was in the middle of the upper surface or the bottom surface. In addition, the laser power and the laser scanning speed have a great influence on the residual stress of the formed part. The results of this study lay a theoretical and experimental basis for the optimization of residual stress and quality control of SLM components.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.