EPJ Web Conf.
Volume 225, 2020ANIMMA 2019 – Advancements in Nuclear Instrumentation Measurement Methods and their Applications
|Number of page(s)||6|
|Section||Nuclear Fuel Cycle|
|Published online||20 January 2020|
The use of self-induced X-ray fluorescence in gamma-ray spectroscopy of uranium ore samples
2 ORANO Mining
3 SEPA/SET ORANO Mining
4 Laboratory of Subatomic Physic and Cosmology, Université Grenoble Alpes, CNRS/IN2P3
Published online: 20 January 2020
Gamma logging for uranium exploration are currently based on total counting with Geiger Müller gas detectors or NaI (TI) scintillators. However, the total count rate interpretation in terms of uranium concentration may be impaired in case of roll fronts, when the radioactive equilibrium of the natural 238U radioactive chain is modified by differential leaching of uranium and its daughter radioisotopes of thorium, radium, radon, etc. Indeed, in case of secular equilibrium, more than 95 % of gamma rays emitted by uranium ores come from 214Pb and 214Bi isotopes, which are in the back-end of 238U chain. Consequently, these last might produce an intense gamma signal even when uranium is not present, or with a much smaller activity, in the ore. Therefore, gamma spectroscopy measurements of core samples are performed in surface with high-resolution hyper-pure germanium HPGe detectors to directly characterize uranium activity from the 1001 keV gamma ray of 234mPa, which is in the beginning of 238U chain. However, due to the low intensity of this gamma ray, i.e. 0.84 %, acquisitions of several hours are needed. In view to characterize uranium concentration within a few minutes, we propose here a method using both the 92 keV gamma ray of 234Th and the 98.4 keV uranium X-ray. This last is due to uranium self-induced fluorescence caused by gamma radiations of 214Pb and 214Bi, which create a significant Compton scattering continuum acting as a fluorescence source and resulting in the emission of uranium fluorescence X-rays. The comparison of the uranium activity obtained with the 92 keV and 98.4 keV lines allows detecting a uranium heterogeneity in the ore. Indeed, in case of uranium nugget, the 92 keV line leads to underestimated uranium concentration due to gamma self-absorption, but on the contrary the 98.4 keV line leads to an overestimation because of increased fluorescence. In order to test this new approach, several tens of uranium ore samples have been measured with a handheld HPGe FALCON 5000 detector.
Key words: Self-induced X-ray fluorescence / gamma-ray spectroscopy / germanium detector / uranium mining / MCNP6
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.