EPJ Web Conf.
Volume 248, 2021V International Conference “Modeling of Nonlinear Processes and Systems“ (MNPS-2020)
|Number of page(s)||7|
|Section||Workshop on Advanced Materials Processing and Smart Manufacturing|
|Published online||26 April 2021|
Mathematical Models of the Geometry of Micro Milling Cutters
Moscow State University of Technology “STANKIN”, RU-127055, Moscow, Russia
2 Institute of Intelligent Industrial Technologies and Systems for Advanced Manufacturing of the National Research Council, STIIMA-CNR, IT-20133, Milano, Italy
Published online: 26 April 2021
Micromachining is an up-to-date technology widely used in different advanced areas like electronics, aerospace and medical industries. For manufacturing components with highest precision and lowest surface roughness, small-sized end mills with working diameter of less than 1 mm are often used. In this paper, in order to determine the functional relationships between structural strength, cutting properties and geometry of small-sized cutting tools, the mathematical models of working part of micro milling cutters were derived.
Key words: Micro milling cutter / micro machining / mathematical modelling.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.