EPJ Web Conf.
Volume 183, 2018DYMAT 2018 - 12th International Conference on the Mechanical and Physical Behaviour of Materials under Dynamic Loading
|Number of page(s)||2|
|Published online||07 September 2018|
A testing technique to investigate the tensile behavior of propellant representative material
Univ. Grenoble Alpes,
2 Ariane Group, “le Bouchet” Research Center, F-91710 Vert-Le-Petit, France
* Corresponding author: email@example.com
Published online: 7 September 2018
Propellants are energetic materials abundantly used to generate the propulsion of rockets, projectiles, or other objects. A wide range of stress-state and strain-rate has to be considered in view of predicting the mechanical behaviour of this material over its different life cycles. Propellant materials are usually studied through the use of propellant representative materials (PRM) when studied in a university laboratory. In the present work an experimental device was developed to investigate the dynamic tensile response of a PRM material. This device is based on the use of a pendulum that is employed to dynamically load the PRM sample on one end. The sample is attached to an instrumented Hopkinson bar on the other end. The data processing of Hopkinson bar point measurements combined to DIC (digital-imagecorrelation) measurements allows the stress and strain levels in the sample to be characterised. Finally these experimental results can be used to enhance the constitutive modelling of PRM materials.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.