EPJ Web Conf.
Volume 146, 2017ND 2016: International Conference on Nuclear Data for Science and Technology
|Number of page(s)||4|
|Section||Nuclear Reaction Measurements|
|Published online||13 September 2017|
Investigation of the 27Al(d,x)24Na nuclear reaction for deuteron beam monitoring purpose
1 Department of Physics, University of Malaya, 50603 Kuala Lumpur, Malaysia
2 Nishina Center for Accelerator-Based Science, RIKEN, Wako, Saitama 351-0198, Japan
3 Nuclear Data Section, Division of Physical and Chemical Sciences, Department of Nuclear Sciences and Applications, International Atomic Energy Agency, 1400 Vienna, Austria
a e-mail: email@example.com
Published online: 13 September 2017
Activation cross-sections for the 27Al(d,x)24Na nuclear reaction was measured by using a stacked-foil activation technique combined with high purity germanium (HPGe) γ-ray spectrometry over deuteron energy range of 2–24 MeV. Measured data were critically compared with the available literature data and also with the theoretical data extracted from the TENDL data base. Accuracy of the 27Al(d,x)24Na cross-sections were confirmed by the simultaneous measurements of the natTi(d,x)48V monitor reaction cross-sections. Present results reproduced well the IAEA recommended natTi(d,x)48V reaction cross-sections, but provide slight deviation with the IAEA recommended 27Al(d,x)24Na cross-sections. It may be concluded that the use of 27Al(d,x)24Na in deuteron beam monitoring should not be a perfect choice if one has the option to use the natTi(d,x)48V reaction.
© The Authors, published by EDP Sciences, 2017
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.